 More KEMET Product News
For more information on KEMET products, please: e-mail us or call 1.800.56.SONIC. |
The FO-CAP combines two existing KEMET technologies - Open Mode Chip Design and Flexible Termination. The Open Mode component utilizes an internal electrode design which minimizes the possibility of a short circuit condition if mechanically damanged (cracked). The Flexible Termination component utilizes a conductive silver epoxy in order to establish pliability while maintaining terminal strength, solderability and electrical performance. The combination of these two technologies provides the highest level of protection against the onset of mechanical failures that may occur during extreme environmental or handling conditions.
"KEMET's FO-CAP addresses concerns for more flex-robust and reliable products in automotive and general electronics applications," said Tim Hollander, KEMET Speciality Product Manager. "This proven technology is available in commercial and automotive grade, and provides superior flex performance and improved reliability while minimizing the risk of a catastrophic and costly failure."
Flexible Termination technology was developed to address flex cracks, the primary failure mode of surface ount MLCCs. This technology directs circuit board stress aaway from the ceramic body and into the termination area, therefore reducing the risk of mechanical damange to the component that can result in low IR or short circuit failures.
Technical Information:
- Operating temperature range of -55°C to +125°C
- Open Mode/Fail Mode design
- Mid to high capacitance flex mitigation
- Pb-Free and RoHS compliant
- X7R Dielectric (Temperature Characteristic = ±15% from -55°C to +125°C)
- EIA 0805, 1206, 1210 and 1812 case sizes
- DC voltage ratings of 16V, 25V, 50V, 100V and 200V
- Capacitance offerings ranging from 1000pF to 6.8μF
- Available capacitance tolerances of ±5%, ±10% and ±20%
- Non-polar device, minimizing installation concerns
- 100% pure matte tin plated termination finish allowing for excellent solderability
- SnPb termination finish option available upon request (5% min)
- Commercial and Automotive (AEC-Q200) grades available
|
